Visit Amazon.com (https://amzn.to/38NHJmQ) or LeatherHoney.com (https://bit.ly/3kiRtYJ) and use code SAMCRAC20 to get 20% off your Leather Honey Complete Leather Care Kit through August 31st, 2023! This video is sponsored by Leather Honey, Amazon’s #1 best-selling leather care products.
Our Flood Totaled ZR-1 Won’t Stop Smoking, Overheating, and Dying. After figuring out its fuel issues, we resolve our Exhaust Issues once and For All with a Made in the USA @STAINLESSWORKSNET Full Exhaust System
The Affordable Topdon Thermal Imaging Camera I Use in this Video:
iOS: https://amzn.to/3BYni1w
Android: https://amzn.to/3oymQUI
Instagram: https://www.instagram.com/samcracc/
Facebook: https://www.facebook.com/SamcracAuto/
Email Me: SamcracAuto@gmail.com
Lose the tips
challanging but GOLD.. Love the Retroo….Corvette… damn. good
The exhaust tips are a piece of shit!!! 🙂
The tips either need removed or tucked in. That is an awful look
I did not know what the one to four light was, I saw it go on earlier, then saw on a forum that it causes issues lol.
Tail pipes extend too far out for my taste…. I’d shorten them…
That’s a tight squeeze under there bro!!!!
Greetings from Poland.
Ramps on soft dirt…what could go wrong?
Why not,,hide food,as in horse saddles??
16:46 bless you 😂
I am not sure if I just love your videos or that you remind me of Tony Shalhoub. Either way, great work mate.
Can you share the source of cam position sensor?
Hey Sam, I have repaired many of these C4 corvettes and the most common issue is the two engine temperature sensors, One runs the fan control and the other runs the ECU feedback. Both are usually bad and may have been switched with generic sensors, only use NTK or the original GM sensors as the others do not report correctly and are critical for engine performance. The initial overheat is usually due to the electric fans not operating or the relay for the fan controller being bad (Drivers side engine compartment in front of the battery). GM did not tie the two temp sensors together in the ECU and they both run independently of each other. the next one is to check the fan/fans (some have two others have one) for operation by manually powering them up. The ECU temp sensors when bad will give you hard starting, especially when the engine is hot and a lack of power is another symptom as it can not control the fuel content correctly. This is due to reading the engine temperature incorrectly (Usually creates heavy smoke due to running to rich once hot). last but not least is the fuel injectors. they are prone to fail on these and will take down more then one cylinder or just will not provide enough fuel. And yes I do run and own my own shop if you did not already guess.
Hope this helps with the diagnostics a little.
Don’t like the exhaust tips
There’s this device called a funnel, it will help with that fuel fill issues
If a person has a lift i wonder why not to use it?
Kust because those exhaust tips are period, doesn't make them cool. They look terrible IMO. Just fit four separate tips man! Great work, can't wait to see you actually clean the damn car up! It annoys me how you leave even the lot scribbles on the windscreen!
Two comments. First, it is important to torque the knock sensor to the correct value. Back in the day the service manuals used to warn about this. It is a type of microphone so too much or too little torque can change its sensitivity. Second, I would really work on getting a scan tool that works with GM OBD-I. There must be a few out there. You really need the full display of values to see what's going on with the engine.
i'm going through my own C4, but its a 96 LT1. Its not a cakewalk, but its going along. its a journey but its worth it. keep them on the road. especally ZR1s.
I LOVE THIS CORVETTE MINI SERIES
Part it out or find an abandoned rock quarry and make it disappear.
Those tips 🤮🤢🤦🏼♂️
We need a new zr1 episode. Been 3 weeks
Ugly tips
horrible looking exhaust tips, very tacky — dammit Sam, its a ZR1, KEEP IT STOCK!