Short throw shifter. In this video I show you how a short shifter works and how to install one in your car. I also compare the difference between a stock shifter and an aftermarket short throw shifter so you can see the drastic improvement in the DriftStang!

Short Shifter: https://goo.gl/IhF5R5
Thread Locker: http://amzn.to/2eWFcYY
Feeler Gauge: https://amzn.to/39jzNEK
RTV Gasket Maker: http://amzn.to/2fP16Lr
Small Torque Wrench: http://amzn.to/2g9y2T8
Plastic Gasket Scraper: http://amzn.to/2eSs6IR
Bushing: https://goo.gl/69iSgj
Silicone Gasket: https://goo.gl/g9M7ay

*This exact procedure works on 1982-2004 Mustangs with a T5 or T45 manual transmission. The process is similar on most other manual cars.

→ Become a ChrisFix Subscriber: http://www.youtube.com/subscription_center?add_user=paintballoo7
→ Instagram: https://www.instagram.com/chrisfixit
→ Facebook: https://www.facebook.com/chrisfix8
→ Website: http://www.ChrisFixed.com
→ My Channel Home Page: https://www.youtube.com/ChrisFix

**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every Week**

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.

source

By elboriyorker

HOSTING BY PHILLYFINESTSERVERSTAT | ANGELHOUSE © 2009 - 2024 | ALL YOUTUBE VIDEOS IS A REGISTERED TRADEMARK OF GOOGLE INC. THE YOUTUBE CHANNELS AND BLOG FEEDS IS MANAGED BY THERE RIGHTFUL OWNERS. POST QUESTION OR INQUIRIES SEND ME AN EMAIL TO elboriyorkeratgmailcom (www.phillyfinest369.com)

42 thoughts on “How to Install a Short Throw Shifter”
  1. I bought the car with all mix matched bolts for the shifter does anyone know what the size is for the four bolts that mount the shifter?

  2. How do I remove shifter that is stuck with too much RTV gasket??? My son installed it and im afraid to damage the trans housing if I use hammer.

  3. To be grammatically correct, It's "a lot shorter throw", not "a lot shorter of a throw". Also, "a lot tighter fit", rather than "a lot tighter of a fit". Just delete the of a in both cases and you'll be good to go. Happy Motoring.

  4. I'm a '96 GT 4.6L 2V V8 Pony owner and I'm a devout follower Chris Fix Christ! I believe in Him because He hasn't failed me once! 'Stangs to the End of the Road!!!

  5. I hope you see this. I was wondering with my car when i shift it leaves and enters new gears realy easily i dont have to apply force. In the video it looks like you have to force it in gear. Is there Maybe something wrong with my shifter or is it just a difrence between cars. I drive a Daihatsu trevis

  6. I have an MGW tr3650 (race model with the shortest throw) on my 03 GT. I highly recommend it over the Steeda model. Pricey…(I think it's down to $250 now) but very nice and close to the best you can get, throw and overall quality IMO.

  7. Switched out the stock gear shift with the same one you got on the video. I also got a new lower boot that seemed cheaply made…all from LMR. Now I am getting some noise that coming up through the gear shifter that wasn't there before. Should I reuse the old lower boot and see what happens? And thoughts as to why I would be getting noise now? I also bought the gasket and the small cup thingy. It shifts great but sounds noisier than before. Not terribly noisy but it is letting sound in now. Thanks

  8. ty so much for this video! i bought a 1996 mustang gt and remembered you had made a whole serie on how to modify this car and today i finally installed my pro 5.0 short throw shifter and as a person who never worked too much on his car except the really basic maintenance things, your video helped me so much. i followed your video step by step and everything was super easy to do. funny enough, i broke my dollar store rachet trying to unbolt the same bolt you had issue with😂. after my brother brought more tools, we finished the installation and the improvement it gives was reallly worth it! ❤

  9. My parents be wondering why they keep hearing hey guys chris fix here😂 love the videos very educating anfd entertaining thank you

  10. Tbh I know a church member, he has a seizure and is joe in a wheel chair, he’s selling his 98 mustang gt for a good price I’m thinking of getting it😏

Comments are closed.